The fun began today putting the Destroyer engine back together, it's been about 3 years since I had issues with the front head/valve issues. I put this off until now to get many personal and high priority matters taken care of, family matters are always first priority, also matters with close friends the past couple of years have been a high priority as well, then getting on with work and increasing responsibilities the past few years have really diverted my energy and attention away from the Destroyer until now, all these other matters are under control, so here we are & here we go!!!!!!!!!!
This build will involve new CP pistons for the Destroyer spec engine & valve specifications, Dyer Rods, treated ROD bearings, stock main bearings, deleted the counter balancer, had the crank shaft re-balanced to the new pistons & rods, fresh clutch.
I think I am going to put in the revised oil pump found on later model street models.
The previously refreshed heads with new valve springs, guides and valves.
I am taking this project slowly & carefully to prevent careless mistakes which caused my last build to have issues. :banghead:
If I am lucky to get her back together this summer, a few break in passes will follow, I need to drop a lot of weight to get back where I was in 2013, I'll be working on that as we proceed currently at 265#, would like to be at 180 to 200.:barf:
This build will involve new CP pistons for the Destroyer spec engine & valve specifications, Dyer Rods, treated ROD bearings, stock main bearings, deleted the counter balancer, had the crank shaft re-balanced to the new pistons & rods, fresh clutch.
I think I am going to put in the revised oil pump found on later model street models.
The previously refreshed heads with new valve springs, guides and valves.
I am taking this project slowly & carefully to prevent careless mistakes which caused my last build to have issues. :banghead:
If I am lucky to get her back together this summer, a few break in passes will follow, I need to drop a lot of weight to get back where I was in 2013, I'll be working on that as we proceed currently at 265#, would like to be at 180 to 200.:barf: