I have 2 DDM tuning kits on my bike. They are both 35w in combination with the RJ mod (jumper to high beam)
When I would turn the ignition switched, I would get an electrical noise and sometimes the lights would not come on, other times they would. I would have to turn the switch off then back on. Normally this process worked, sometimes I would have to repeat.
I installed the ddm single relay and it eliminates this issue. I flipped the switch on and off about 10-15 times and no electrical noise, and the light stays on fine.
DDM recommends using this relay if your lights are daytime running. Our low beams are drl's.
Hope this helps folks out.
When I would turn the ignition switched, I would get an electrical noise and sometimes the lights would not come on, other times they would. I would have to turn the switch off then back on. Normally this process worked, sometimes I would have to repeat.
I installed the ddm single relay and it eliminates this issue. I flipped the switch on and off about 10-15 times and no electrical noise, and the light stays on fine.
DDM recommends using this relay if your lights are daytime running. Our low beams are drl's.
Hope this helps folks out.